Advertisement
F.
Locate the code for the desired device in the code set table (brands are listed in
alphabetical order).
G.
Enter the first four-digit code for you device. If you perform this procedure correctly, the
selected mode key will blink twice.
Note: If you enter an invalid code, the selected device key will fast blink 7 times. Device
program mode will be terminated.
H.
Aim the remote control at your device and press the "Power" once. The device should be
turn off. If it does not respond, repeat the above steps.
Searching for Your Code
A.
If your home entertainment device does not respond to the remote control after trying all
codes listed for you brand, or if your brand is not listed at all, try searching for your code.
B.
For example, after trying all of the code for your TV, you still cannot get the remote
control to operate your TV, then:
C.
Turn on your TV
D.
On the remote control, press TV once. Then press and hold SETUP until the TV key blinks
twice, then release SETUP
E.
Press the POWER key once
F.
Aim the remote control at the TV
G.
Press either the "CHANNEL UP" key or "CHANNEL DOWN" key to do device auto-
scan:
1. Press the "CHANNEL UP" key to start searching upward at an approx. 5 seconds interval
for each code set. The TV key will be on and blink every 5 seconds while in the device
scan mode.
Note: In this search mode, the remote control will send IR codes from the library starting
from the lowest code set number to the end of code set for that device;
2. Press the "CHANNEL DOWN" key to start searching downward at an approx. 5 seconds
interval for each code set. The TV key will be on and blink every 5 seconds while in the
device scan mode.
Note: In this mode, the remote control will send IR codes from the highest code set
number to the beginning of code set of that kind of device
H.
If the TV turns off, a working code has been found. Press OK once to lock in the code. The
selected mode key will blink twice
I.
To search for the codes of other devices, repeat the above but substitute the AUX key for
the auxiliary device you are searching for.
J.
If all code sets of that device is exhausted in the search and the OK is not pressed, the
selected device key will fast blink 7 times and the search mode will be terminated.
Universal Remote Control User's Manual
OR
Page 2
Advertisement
