Radiant DVMD14 User Manual

Digital video motion detector

Advertisement

Quick Links

Hardware User's Manual
Digital Video Motion Detector
June, 2013
Radiant, Inc.
2395 Kenwood Drive
Boulder, CO 80305
Phone: (303) 543-0440
Fax: (303) 543-2126

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DVMD14 and is the answer not in the manual?

Questions and answers

Summary of Contents for Radiant DVMD14

  • Page 1 Hardware User’s Manual Digital Video Motion Detector DVMD14 June, 2013 Radiant, Inc. 2395 Kenwood Drive Boulder, CO 80305 Phone: (303) 543-0440 Fax: (303) 543-2126...
  • Page 2 DVMD14 in a system. It outlines a variety of set-up features. Please also refer to the XPORT User Manual to change the IP address and Local Port number for each DVMD14. The minimum DVMD14 configuration must contain: At least one DVMD14 with ISO type AC power cord •...
  • Page 3 Product: DVMD14 Part Number: 800-000 Physical 2U chassis with 19” rack mounting tabs. Weight: 14 Pounds (including 14 modules) Black Powder coat finish on metal chassis. Video Processor Installation The expanded area of the chassis shows a single Video Processor installed in slot “0”...
  • Page 4 The user may customize the Video Processor for site specific operating environments by means of a network connection to a HOST PC that is executing the ManagerNETxxx.exe graphical user interface (GUI). The GUI allows the user to modify the settings and mask of the DVMD14. Each version of this software is zipped and posted at in the “SUPPORT”...
  • Page 5 Connection to HOST PC Each DVMD14 may be connected to a HOST PC NIC card using a “Reverse CAT5” cable, or to a hub or router with a “Straight-Through CAT5” cable. The PC will run the ManagerNETxxx.exe program, establish a network connection to the DVMD14 and allow changes.
  • Page 6 DO-, and two wires are for DI+ and DI-. Shield may be used to keep the common mode voltage of the camera and the DVMD14 transceivers within the +12 to -7V range. If Shield is used there will be ground loop currents flowing and care must be taken to insure that the power supply of the camera can float (via isolated transformer) with respect to the DVMD14 ground.
  • Page 7 DO- pair should be connected to the DI+ and DI- pair of the PTZ camera. User Interface – Software The DVMD14 is configured with a Windows Graphical User Interface that is available as a download from the Radiant website. ManagerNETxxx.zip contains several Windows programs that may be used with the DVMD14.

Table of Contents