Maintenance - HoMedics VC-110 Instruction Manual

• NEVER use this product while in bed.
• This product should NEVER be used by any individual suffering from
any physical ailment that would limit the user's capacity to operate the
controls or who has sensory deficiencies.
• This unit should not be used by children without adult supervision.
• DO NOT use this product on any wooden surface as it may cause
damage.
Instructions for Use
Please Note:
For Use in Home or Office
For your safety, this
1. Plug adapter into a 120 volt AC outlet and plug
product is equipped
the receptacle end into the input jack, located in the
with a pressure
bottom of the integrated control on the cushion.
activated switch
2. Attach the massage cushion to any chair using the
to control the heat
integrated strapping system to secure the cushion.
function. Heat will
3. Press the massage button on the control panel
not operate unless once for low intensity massage (Fig. 1). Press it
again for high intensity massage.
pressure is applied
4. To activate heat function, press the heat button
to this switch,
once (Fig. 1) . Press the heat button again to
located on the seat
deactivate the heat function.
cushion of the unit
Note: When selecting the heat feature, there will
(see page 7). Once
be a slight decrease in the strength of the massage
pressure is removed,
output. This adjustment is perfectly normal and
heat will turn off. After
should not be interpreted as a defect.
applying pressure,
5. To turn the unit off, simply press the massage
button a third time.
please allow 5-10
minutes for heat
to reach maximum
For Use in Your Car
temperature.
1. Simply plug the 12 volt auto adapter into a 12V DC outlet and plug
the receptacle end into the input jack, located along the side of the cushion.
2. Slip the massage cushion straps over your seat.
3. Follow steps 3-5 above for operation.
4

Maintenance

Please Note:
Not recommended
To Store
for use on wooden
Place massager in its box or in a safe, dry, cool place. Avoid contact with sharp
surfaces as
edges or pointed objects which might cut or puncture the fabric surface. To avoid
the zipper may breakage, do not wrap the power cord around the unit. Do not hang the unit by the
controller cord.
damage the wood.
Caution is also
To Clean
recommended
Unplug the unit and allow it to cool before cleaning. Clean only with a soft, slightly
when using on
damp sponge. Never allow water or any other liquids to come into contact with the
upholstered
unit.
furniture.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, gasoline, kerosene, glass/furniture polish,
• Do not attempt to repair the massager. There are no user serviceable parts. For
Fig. 1
paint thinner to clean.
service, call the Consumer Relations telephone number listed in the warranty section.
5