Behringer Ultragain digital ADA8200 Quick Start Manual page 6

10
ULTRAGAIN DIGITAL ADA8200
ULTRAGAIN DIGITAL ADA8200 Controls
(1) (2) (3) (4) (5)
(10) (11) (12) (13) (14)
(6) (7) (8)
(15)
11
Quick Start Guide
Step 2: Controls
(EN)
(9)
(1) SIG LED indicates an input signal. This LED 8-CHANNEL DIGITAL I/O ADAT IN sends
(12)
illuminates when an audio signal is present 8 channels of digital audio input from an
at one of the inputs. ADAT device to the 8 analog line outputs.
This input connects to other ADAT devices via
(2) CLIP LED indicates the input signal level
TOSLINK cable.
is too high. This LED illuminates when the
audio signal peaks in the channel. Adjust the Word Clock Input connects to external
(13)
gain knob to reduce the signal level and devices for word clock synchronization.
avoid clipping. This BNC connector is only active when
the SYNC selector (see 14) is switched to
(3) MIC IN connects XLR microphone
SLAVE > WC IN. All devices within the
or instrument input to Midas
system (i.e. digital mixer, digital recorder,
designed preamplifiers.
or computer recording interface) must be
(4) GAIN knob adjusts the channel input level. synchronized via a shared word clock signal.
The gain knob adjusts the input level for
SYNC (Word clock settings selector)
(14)
either the MIC IN or LINE IN connection.
designates internal or external word clock
(5) LINE IN connects 1/4" TRS input at line level. configuration and sample rate. If the
ADA8200 is slaved to an external word
(6) SYNC MASTER LED indicates that the
clock source, select either WC IN or ADAT IN
ADA8200 is the master word clock source.
according to your word clock connection.
External word clock devices receive their
If the ADA8200 is functioning as the
sync signal from the ADA8200.
master word clock source for external ADAT
(7) SYNC LOCKED LED illuminates when the devices, select the appropriate sample rate
ADA8200 is the master word clock source, (either 44.1 or 48 kHz).
or when receiving a valid sync signal from an
LINE OUT XLR male connectors send
(15)
external word clock source (via either ADAT
D/A converted audio output from
or word clock in).
ADAT IN connector.
(8) PHANTOM POWER +48 V switches
the +48 V phantom power on and off.
Phantom power is active on all MIC IN inputs
when engaged.
(9) ON/OFF POWER switch turns the ADA8200
on and off.
Power is supplied via an IEC cable connected
(10)
to the mains. An IEC cable is provided.
8-CHANNEL DIGITAL I/O ADAT OUT
(11)
sends 8 channels of digital audio output
from the analog inputs to an ADAT device.
This output connects to other ADAT devices
via TOSLINK cable.