Advertisement
① IR sensor
② Laser pointer beam
③ LCD Display
④ ℉/℃select key
⑤ Backlight select key
⑥ Laser select key
⑦ Measurement Trigger
8
Battery Cover
4. 4. 4. 4.
INDICATOR
INDICATOR
INDICATOR
INDICATOR
① Digital readout
② Temperature ℃ (Celsius)
③ Temperature ℉ (Fahrenheit)
④ Data Hold
⑤ Measuring indication
⑥ LOW battery indicator
⑦ Laser Point
8
Fixed emissivity (0.95)
9
Max Min
5. 5. 5. 5.
MEASURMENT OPERATION
MEASURMENT
MEASURMENT
MEASURMENT
OPERATION
OPERATION
OPERATION
① Hold the meter by its Handle
② Pull and hold the Trigger
the battery is good. Replace the battery if the display does not light.
③ While measuring, the SCAN display icon will appear in the upper left hand corner of the
LCD.
④ While continuing to pull the Trigger:
a.
Push the Laser
laser icon
beam approximately a half inch above the point of test (pressing the Laser
button again turns the laser off).
b.
Select the temperature units (
c.
Push the Backlight
⑤ Release the Trigger and the HOLD display icon will appear on the LCD indicating that
the reading is being held.
⑥ The meter will automatically power down after approximately 7 seconds after the trigger
is released.
Note:
Note:
Note: Measurement
Note:
Measurement
Measurement
Measurement considerations
Holding the meter by its handle, point the IR Sensor toward the object whose temperature is
to be measured. The meter automatically compensates for temperature deviations from
ambient temperature. Keep in mind that it will take up to 30 minutes to adjust to wide ambient
Handle
Grip
Handle
Handle Grip
Grip
Grip and point it toward the surface to be measured.
Trigger to turn the meter on and begin testing. The display will light if
Trigger
Trigger
Laser
Laser button to turn on the laser pointer. When the laser is on the
Laser
will appear on the LCD over the temperature. Aim the red
Backlight
Backlight
Backlight key to turn on the LCD backlighting function.
considerations
considerations
considerations
o o o o
o
o
C C C C and
C or
F) using the
o o o o
F F F F buttons.
Advertisement
