Table of Contents
Advertisement
STEP 4
Remote DC Control Hookups
NOTE:
This feature allows you to turn on/off your PowerCenter via your Home Automated Control System.
A component you don't want powered constantly (such as your projector or surround amplifier) can be plugged
into one of the PowerCenter's outlets programmed as "switched on" or "switched on after delay" and be remotely
activated when needed. This feature also allows you to use a low voltage cable (not supplied) to remotely control
multiple PowerCenters.
You can't turn off the PowerCenter using the front panel OFF button when the unit is operating in the REMOTE mode.
A) Plug a 1/8" mini-plug cable (not supplied) into the corresponding outlet on the PowerCenter
(see diagram below).
B) Switch the REMOTE ON/OFF switch (located on the back of the PowerCenter) to REMOTE ON.
C) Plug the other end of the cable into the corresponding outlet on your component that has a 12 volt
output. When you turn on the component that has a 12 volt output, the PowerCenter's outlets programmed
as "switched on" will be turned on immediately. However, the PowerCenter's outlets programmed as
"switched on after delay" will be turned on after a delay set by the DELAY TIME switch.
GROUND
1
2
3
4
5
CABLE TV
IN
OUT
OUTLET PROGRAMMING SWITCHES
UNSWITCHED SWITCHED DELAY NO DELAY
1
2
SATELLITE
REMOTE
IN
OUT
3
AC IN
110V
4
0.3A
5
DELAY
TIME
SHORT
LONG
SWITCH
(6 seconds)
(20 seconds)
ANTENNA
DELAYED
TRIGGER
SWITCHED
IN
OUT
DC IN
OUT
3~30V
DC OUT
SWITCH
9~12V
300MA
IN
OUT 1
PHONE
OUT 2
BREAKER 15A
PRESS TO RESET
1800W MAX TOTAL
10
Hide quick links:
Advertisement
Table of Contents
