Weider Cardio Pacer 2.0 Treadmill User Manual
Weider Cardio Pacer 2.0 Treadmill User Manual

Weider Cardio Pacer 2.0 Treadmill User Manual

English manual

Advertisement

Quick Links

Model No. WLTL01806.0
Serial No.
Serial Number
Decal
QUESTIONS?
As a manufacturer, we are com-
mitted to providing complete
customer satisfaction. If you
have questions, or if parts are
damaged or missing, PLEASE
CONTACT OUR CUSTOMER
SERVICE DEPARTMENT
DIRECTLY.
CALL TOLL-FREE:
1-866-699-3756
Mon.–Fri., 6 a.m.–6 p.m. MST
ON THE WEB:
www.wesloservice.com
CAUTION
Read all precautions and instruc-
tions in this manual before using
this equipment. Save this manual
for future reference.
USER'S MANUAL
Visit our website at
www.weslo.com
new products, prizes,
fitness tips, and much more!

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Cardio Pacer 2.0 Treadmill and is the answer not in the manual?

Questions and answers

Summary of Contents for Weider Cardio Pacer 2.0 Treadmill

  • Page 1 Model No. WLTL01806.0 USER’S MANUAL Serial No. Serial Number Decal QUESTIONS? As a manufacturer, we are com- mitted to providing complete customer satisfaction. If you have questions, or if parts are damaged or missing, PLEASE CONTACT OUR CUSTOMER SERVICE DEPARTMENT DIRECTLY.
  • Page 2: Table Of Contents

    TABLE OF CONTENTS IMPORTANT PRECAUTIONS ..............2 BEFORE YOU BEGIN .
  • Page 3: Before You Begin

    BEFORE YOU BEGIN Thank you for selecting the new WESLO ® number and serial number before calling. The model CARDIOPACER 2.0 treadmill. The CARDIOPACER number of the treadmill is WLTL01806.0. The serial 2.0 treadmill is designed to let you enjoy effective car- number can be found on a decal attached to the tread- diovascular workouts in the comfort and convenience mill (see the front cover of this manual for the location).
  • Page 4: Assembly

    ASSEMBLY Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included tools and your own rubber mallet Use the drawings below to identify the hardware used during assembly. Note: If a part is not in the parts bag, check to see if it has been preattached to one of the parts to be assembled.
  • Page 5 2. Identify the Left Upright (3), which has the Upright Wire (46) inside. Orient the Left Upright as shown, and attach it to the left Upright Base (16) with two M10 x 55mm Screws (13), four M10 Washers (14), and two M10 Nuts (18). Do not tighten the Nuts yet.
  • Page 6 4. Position the Frame (41) between the Left and Right Uprights (3, 9). Attach the Frame to the Uprights with two M12 x 60mm Screws (11) and two 12mm Washers (12). Connect the Upright Wire (46) in the Left Upright (3) to the wire from the Reed Switch (23).
  • Page 7 7. Insert the Frame Pin (45) through the Right Upright (9) into the hole in the Frame (41). Hole 8. Make sure that all parts are properly tightened before you use the treadmill. To protect the floor or carpet, place a mat under the treadmill.
  • Page 8: Treadmill Operation

    TREADMILL OPERATION LUBRICATING THE WALKING PLATFORM The console features five modes: Before the treadmill is used, the walking platform • Scan—This mode displays the Time, Speed, should be lubricated. Open the included lubricant Distance, and Calories modes. packet. Reach under one side of the walking belt as •...
  • Page 9 3. Turn off the console. 3. Insert the frame Right pin through the Upright To turn off the console, simple wait for a few min- lower end of the utes. If the walking belt is not moved and the con- right upright into sole button is not pressed for a few minutes, the the hole in the...
  • Page 10 HOW TO ADJUST THE INCLINE The treadmill features two incline levels. To change the incline, first fold the treadmill to the storage position Storage Hole (see HOW TO FOLD THE TREADMILL FOR STOR- AGE on page 9). Next, locate the two Rear Feet (39). To decrease the incline of the treadmill, remove the Rear Feet and tighten them into the round tube on the Frame (41).
  • Page 11: Maintenance And Troubleshooting

    MAINTENANCE AND TROUBLESHOOTING Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual. 1. SYMPTOM: THE CONSOLE DOES NOT 3.
  • Page 12: Conditioning Guidelines

    CONDITIONING GUIDELINES Aerobic Exercise The following guidelines will help you to plan your exercise program. Remember that proper nutrition and adequate rest are essential for successful results. If your goal is to strengthen your cardiovascular sys- tem, your exercise must be “aerobic.” Aerobic exercise is activity that requires large amounts of oxygen for WARNING: prolonged periods of time.
  • Page 13 SUGGESTED STRETCHES The correct form for several basic stretches is shown at the right. Move slowly as you stretch—never bounce. 1. Toe Touch Stretch Stand with your knees bent slightly and slowly bend forward from your hips. Allow your back and shoulders to relax as you reach down toward your toes as far as possible.
  • Page 14: Part List

    PART LIST—Model No. WLTL01806.0 R0906A Key No. Qty. Description Key No. Qty. Description Handrail Endcap Walking Platform Short Foam Grip Front Roller Assembly Left Upright Right Foot Grip M6 x 15mm Screw Platform Bolt Handrail Bumper Long Foam Grip Roller Guard Screw Latch Assembly Roller Guard Latch Screw...
  • Page 15: Exploded Drawing

    EXPLODED DRAWING—Model No. WLTL01806.0 R0906A...
  • Page 16: Ordering Replacement Parts

    ORDERING REPLACEMENT PARTS To order replacement parts, please see the front cover of this manual. To help us assist you, be prepared to give the following information: • the MODEL NUMBER of the product (WLTL01806.0) • the NAME of the product (WESLO CARDIOPACER 2.0 treadmill) •...

This manual is also suitable for:

Wltl01806.0

Table of Contents