Advertisement
Quick Links
Mounting Pole Kit
Installation Manual
This manual covers use of the Mounting Pole Kit with the Integrated Sensor
Suite (ISS) of the Vantage Pro2
other Davis Instruments stations, applying the principles shown here with
the ISS.
Components
The mounting kit includes the following:
Tools and Materials Needed
In addition to the hardware shown above, you may need some of the
following tools and materials:
•
Adjustable wrench
•
Drill with 1/4" (6 mm) bit
Secure the ISS to the Support Tube
The support tube is 19-1/2" (0.5 m) long, and has a swaged end. After you
secure one or both sides of your ISS to the support tube, this end will be
8" Cable Ties
5/16" x 1-1/2"
U-Bolt
1-1/2" Saddle
5/16" Flat Washers
5/16" Lock Washers
5/16" Hex Nuts
system. The kit can also be used with
TM
Support Tube
(19.5" long, swaged end)
5/16" x 3"
Lag Screws
5/16" Flat Washers
1-1/2" Saddles
Extension Tube (21" long)
1
Advertisement
Related Manuals for DAVIS with the Integrated Sensor Suite (ISS) of the Vantage Pro2TM system
Summary of Contents for DAVIS with the Integrated Sensor Suite (ISS) of the Vantage Pro2TM system
-
Page 1: Installation Manual
This manual covers use of the Mounting Pole Kit with the Integrated Sensor Suite (ISS) of the Vantage Pro2 system. The kit can also be used with other Davis Instruments stations, applying the principles shown here with the ISS. Components... - Page 2 Mount the Extension Tube inserted into the top of the extension tube. Make sure the swaged end of the support tube is pointing downward as you secure the ISS (or other station). The ISS comes with U-bolts, washers, and hex nuts for the purpose of mounting it on a pole.
- Page 3 Install the Support Tube on the Extension Tube Support Tube (swaged end) Saddle Flat Washers 12" Lag Screws minimum Extension Tube (21" long, no swaged end) 4. Tighten the lag screws until the tube will not slide up or down no matter how hard you try to move it.
- Page 4 Rain Collector Heater Installation Manual Rev. C (12/10/08) This product complies with the essential protection requirements of the EC EMC Directive 2004/108/EC. © Davis Instruments Corp. 2008. All rights reserved. 3465 Diablo Avenue, Hayward, CA 94545-2778 U.S.A. 510-732-9229 • Fax: 510-732-9188...