FOR ADVANCED MODELERS, OPTIONAL PHOTO ETECHED METAL PARTS, IF NOT USING PILOT SHOWN IN STEP 3.
This kit contains photo etched parts for added realism. use a sharp knife to remove the parts from their tree and cut against a hard surface like a piece of glass. Stick
a piece of tape to the back of the photo etch tree so the parts don't fly off and get lost. Carefully sand the photo etch pieces to remove any remnants of their mounting
points. Some photo-etched parts will need to be sanded to fit properly. To attach the photo etched pieces to your model, use a toothpick or piece of wire to apply a
small amount of CA superglue, two-part epoxy, or clear enamel paint to your model. Then the photo etched pieces can be put into place using tweezers or a toothpick