Xantech 710-00 Installation Instructions

The Fone Link allows any cordless or wired telephone to function as a remote controller for IR controlled
audio/video components. Used with cordless phones, it provides a control system not affected by sunlight
or any other infrared interference. The Fone Link contains an infrared signal learning microprocessor and
is connected between the cordless or wired phone and the phone line.
Infrared Sensor
710
FONE LINK
Three Blast-IR Emitters
Fig. 1
FRONT PANEL
The front panel of the Fone Link is made of acrylic
plastic. It should be cleaned with a soft cloth as it
scratches easily. Behind the panel are five red LEDs
(light emitting diodes), three powerful Blast IR emit-
ters and an infrared sensor.
RED LED INDICATORS
PROGRAM - Lights when the PROGRAM button
on the rear panel is pressed.
LEARNING - Lights when any key on the tele-
phone is pressed.
ERROR - Lights when an error occurs or ex-
tended memory is required in the learning pro-
cess or when trying to send an unprogrammed
command.
DELETE - Blinks on and off when the DELETE
button on the rear panel is pressed.
OUTPUT - Lights to indicate when infrared com-
mands are being sent in response to pressing
telephone keys.
BLAST IR EMITTERS
Three Blast IR Emitters, for direct IR transmission to
the controlled equipment, are located between the
LEARNING and the DELETE LEDs. See Fig.1.
INFRARED SENSOR
The Infrared Sensor is located about one-half inch
above the OUTPUT LED. See Fig.1.

INSTALLATION INSTRUCTIONS

710-00
FONE LINK™
FRONT VIEW
®
XANTECH CORP, SYLMAR CA.
REAR VIEW
Fig. 2
REAR PANEL
The following connectors, push buttons and controls
are located on the rear panel:
3/6 STRETCH control
Used to set the duration of the extended output
pulses generated when the 3 or 6 keys on the
telephone are pressed.
+12VDC jack
The power supply (included) plugs in here.
OUTPUT jack
External infrared emitters or Xantech connecting
blocks can be plugged-in here. NOTE: When a mini
jack is inserted into the OUTPUT jack for connection
of these devices, the internal Blast IR emitters are
automatically turned off.
BUTTONS (Use pencil point or toothpick)
RESET - erases all stored commands.
DELETE - erases only selected command.
PROGRAM - begins learning sequence.
TELEPHONE JACKS
FROM PHONE
The cordless (or wired) telephone plugs-in here.
TO WALL JACK
The cord from the telephone wall jack plugs-in
here.

FONE LINK™ MODEL 710
FROM TO WALL
PHONE JACK
1