Related Manuals for Tekcomm TCT 1500
Summary of Contents for Tekcomm TCT 1500
-
Page 1: User Manual
Digital Satellite 4000 1.00W Digital Update via audio Receiver TCT 1500 stand-by kanäle User Manual... -
Page 4: Table Of Contents
9.0 subTITlEs 10.0 TRoublE shooTIng 11.0 sPECIfICATIons TekComm declares that this item complies with the basic requirements and other relevant regulations of directives CE 2004/108/EEC and 73/23EEC Rohs 2002/95EEC Subject to alterations. In consequence of continuous research and development technical specifications, design and appearance of products may change. -
Page 5: Introduction
Wait a few seconds after switching off the 1.4 Accessories receiver before you move the receiver or disconnect any equipment. 1. TCT 1500 1x It is a necessity that you only use an approved 2. User’s Manual 1x extension and compatible wiring that is suitable for... -
Page 6: Usage Of External Usb Devices
Changes channel and controls It is recommended to use USB 2.0 storage devices. numeric functions 4. fAv Opens the available favourite TekComm cannot guarantee compatibility to all types list if previously configured of USB storage devices. 5. RECAll Toggles between the two the... -
Page 7: Default Pin Code: 0000
PART 2 • English 17. ColouREd buTTons Connecting multiple fixed dishes to your receiver using a DiSEqC 1.0 switch Fig. 8 For Teletext and further menu functions 3.3 Connecting to a digital 18. Tv/RAdIo In viewing mode toggles between TV and radio mode Audio Amplifier 2.4 default PIn code: 0000 Connect your Digital Audio Amplifier with the S/PDIF... -
Page 8: My Dish
PART 2 • English 4.1.5 Auto Time Zone try to get a high as possible signal for Strength and Quality.) This option allows you to enable Auto Time Zone or to disable Auto Time Zone. 4.2.1.2 disEqC 1.2/usAls If switched ON, it will follow the time zone DiSEqC 1.2/USALS need to be selected if your dish automatically where you are. -
Page 9: Main Menu
PART 2 • English For Toneburst OFF, you can edit 1 dish. that favourite group you like to save. Repeat this operation to remove the channel from the favourite For Toneburst ON, you can edit 2 dishes. list. (Press YElloW button to save.) Press pq to select Receiver and press oK. -
Page 10: Radio
PART 2 • English 5.1.1.8 search 5.3 Accessory , then press oK and use the Press tu to select On Screen Display menu to search for a programme. In Main Menu press tu to move to Accessory and press oK to enter the menu. 5.1.2 EPg (Electronic Programme guide) Press pq to select the following sub-menus The EPG shows the programme schedule for all... -
Page 11: Set Default
PART 2 • English You can use Delete All to delete all channels from 5.4.3.2 Channel lock the list. Press tu to change settings for Channel Lock (Yes or No). REd = Add, gREEn = Del, YElloW = Delete All, bluE = Scan. -
Page 12: Changing Channel List Mode
WARnIng: NEVER disconnect the USB device noTE: Needed parameters can be changed. from the receiver, the receiver from the Please ask your local TekComm main or switch the power OFF during dealer in case software update was the update/backup procedure. It can not successful. -
Page 13: Teletext
PART 2 • English tu and make your selection (Stereo, Left or Right channel). Press oK, Exit and confirm. Your selection will be memorized for the current channel. noTE: Audio tracks containing AC3 can only be listened to if the receiver is connected to a digital audio amplifier and this amplifier is switched ON and set to the correct input. -
Page 14: Trouble Shooting
PART 2 • English 10.0 TRoublE shooTIng There may be various reasons for occurring abnormal operation of the receiver. Check the receiver according to the procedures shown below. If the receiver does not work properly after checking it, please contact the dealer. Don’t open the receiver cover. -
Page 15: Specifications
PART 2 • English 11.0 sPECIfICATIons general data Input Voltage Range: 100-240 V AC 50/60 Hz Power consumption: max 18W, typ. 4.5 W demodulator Modulation: QPSK Stand-by Power consumption: 1.00 W Input Symbol Rate: 2~45 Ms/s Operating Temperature: +0°C ~ 40 ° C SCPC /&... - Page 16 PART 2 • English...
- Page 17 PART 2 • English...
Need help?
Do you have a question about the TCT 1500 and is the answer not in the manual?
Questions and answers