GE JRS0624 Owner's Manual page 16

Before you call for service...
Troubleshooting Tips
Problem
Oven temperature too
hot or too cold
Oven will not work
"F— and a number
or letter" flash
in the display
Display goes blank
Display flashes
Unable to get the
display to show "SF"
Power outage,
clock flashes
Strong odor
16
Possible Causes
Oven thermostat
needs adjustment.
A fuse in your home may
be blown or the circuit
breaker tripped.
Oven controls improperly set.
You have a function
error code.
If the function code
repeats.
A fuse in your home may be
blown or the circuit breaker
tripped.
The clock is in the
black-out mode.
Power failure.
Oven control pads were not
pressed properly.
Power outage or surge.
An odor from the insulation
around the inside of the
oven is normal for the first
few times the oven is used.
What To Do
• See the Adjust the oven thermostat—Do it yourself!
section.
• Replace the fuse or reset the circuit breaker.
• See the Using the oven section.
• Touch the CLEAR/OFF pad. Allow the oven to cool for
one hour. Put the oven back into operation.
• Disconnect all power to the oven for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
• Replace the fuse or reset the circuit breaker.
• See the Special features of your oven control section.
• Reset the clock.
• The BAKE and BROIL HI/LO pads must be touched at
the same time and held for 3 seconds.
• Reset the clock. If the oven was in use, you must reset
it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
• This is temporary.