GE JKP75SM Dimensions And Installation Information

JKP75SM
GE 27" Built-In Convection/Thermal Wall Oven
®
Locate
junction box
for 24"models
Dimensions and Installation Information (in inches)
56" MIN. above
cutout floor
Allow 3/4"
A for overlap
KW Rating
over all edges
of cutout
240V 6.8
208V
5.1
C
Breaker Size
240V
30 Amps
B
208V
30 Amps
Note: Cabinets installed adjacent to wall ovens
must have an adhesion spec of at least a 194°F
G
temperature rating.
Note: If marks, blemishes or the cutout opening is
visible above the installed oven, it may be necessary to
add wood shims under the runners and front trim until
Conduit
the marks or openings are covered.
(48-1/2" Long)
Note: Door handle protrudes 3" from door face. F
Cabinets and drawers on adjacent 45° and 90°
21" MIN.
walls should be placed to avoid interference with
door opening
the handle. allowance
Electric wall ovens are not approved for installation
with a plug and receptacle. They must be hard wired
in accordance with installation instructions.
For answers to your Monogram, ®
GE appliance questions, visit our website at
®
ge.com or call GE Answer Center
800.626.2000.
Suitable
bracing
to support
runners
Cabinet
A – Cabinet width required
21
B – Minimum cabinet depth
C – Opening width
D – Opening height
E – Recommended minimum cutout location from floor
Oven
F – Overall depth*
G – Overall height with trim
Overall height without trim
H – Overall width
*Depth including door handle is approximately 26-7/10" min. to 26-8/10" max.
GE Profile ™ or
service,
®
2" x 4" or
C L
equivalent
runners
18"
Over centerline
of cabinet
(must support 300 lbs.)
27"
27" min.
23-5/8"
25" min. - 25-1/4" max
50-1/8" max
13-1/4"
23-5/8"
51-7/8" - 52-3/4"
51"
26-5/8"
Locate
junction box
for 24"models
56" MIN. above
cutout floor
Locate
10
j unction box
for 27"models
A
either 5" MIN.
below cutout
floor or 44"
MIN. above
cutout floor
C
B
Access
from
adjacent
D
cabinet
required
E
Conduit
(48-1/2" Long)
2" X 4" or
equiv. runners
Minimum
(cutout floor)
cutout location
from floor
Specification Created 2/07
Allow 3/4"
for overlap
over all edges
of cutout
G
Cabinet
A – Cabinet w
21
B – Minimum
C – Opening
D – Opening
F
E – Recomm
21" MIN.
Oven
door opening
F – Overall d
allowance
G – Overall h
H – Overall w
*Depth includi
Listed by
Underwriters
Laboratories
320360
Suitab
bracin
to suppo
runne
Overall h