Kenwood TS-820 Operating Manual page 37

Ssb transceiver

Hide thumbs Also See for TS-820:

Table of Contents

Transceiver Interconnecting Cord

Fig.

Connection of Accessory Remote VFO

REMOTE C O N N E C T I O N S

EXTENSION FEET

Fig. 3 0 shows the REMOTE connector. This 8-pin plug

The TS-820 is provided with t w o extra feet which can be

can be used for attaching linear amplifiers. or other external

used to raise the front panel of the transceiver. I n some

accessories to the transceiver.

operating positions the tilt makes it easier to read the dial

and meter. Fig. 3 1 shows h o w to install the feet.!

r - - - - - - 1 R L

Fig. 31. Attaching t h e Extension Feet

external speaker

FIXED C H A N N E L CRYSTAL INSTALLATION

Fig. 3 0 Remote Connector

Section 4.15 describes fixed channel operation with the

TS-820. To install the accessory crystals. remove the trans-

ceivers bottom cover and locate the FIX-VOX board side the

power transformer.

Insert the crystal in the desired channel position (the posi-

tions are labeled on bottom of the case) and use the appro-

priate trimmer (TCl through TC4) to net the crystal. The

CAL-FIX feature of the TS-820 can be used to net the cry-

stals as described in Section 4.4.

Table of Contents