Kenwood AT-130 Instruction Manual page 10

1. General lnformation
Your AT-130 has been factory aligned and tested
include a photocopy of the bill of sale,
or other proof of purchase showing the
to specification before shipment. Under normal
date of sale.
circumstances, it wili operate in accordance with
these operating instructions.
If your unit fails to work, contact the authorized
dealer from which you purchased it for quick,
Dear OM, if you desire to correspond on
a technical or operational problem,
please make your note short, complete,
reliable repair.
and t o the point. And PLEASE make
Attempting service without factory authorization
it readable.
can void the unit's warranty.
Please list: Model and serial number.
2. Ordering Spare Parts
The question or problem you are
When ordering replacement or spare parts for
having.
Please give sufficient detail t o diagnose; other
your equipment, be sure to specify the following:
T
-
equipment in the station, meter readings and
Model and serial number of your transceiver,
anything you feel might be useful in attempting
w
Schematic number of the part. Printed circuit
diagnosis.
3. Service
You may return your unit for service either t o
the Authorized Kenwood Dealer from whom you
purchased it or to Trio-Kenwood. A copy of the
service report will be returned with the unit.
Please do not send sub-assemblies or printed
circuit boards-send the complete unit, in i t s
original boxes and packing.
You need not return accessory items unless they
are directly related t o the service problem.
4. Dial Lite lnformation
Part
#
B30-9996-00
Rating 12V 40mA
To replace:
1. Remove top cover.
2. Note position of all leads on S meter and
lamp P.C.B.
3.
Remove all leads from meter and lamp
P.C.B.
I f you want verification of receipt, please supply
4. Remove meter bracket.
a self-addressed card (or letter) and we will
5. Remove 2 brass Philips screws holding
inform you of the date of receipt and estimated
lamp P.C.B. to meter.
service time.
6. Swing P.C.B. rear edge up and out.
NOTE: When claiming warranty service, please
8.
Reverse disassembly procedure.
c
1