GE Spacemaker 164 D2588P191 Use And Care Manual page 33

PROBLEM
OVEN WEL NOT
COME ON
CONTROL PANEL
LIGHTED, YET OVEN
ON DISPLAY
FLOOR OF THE OVEN
IS WARM, EVEN
HAS NOT BEEN USED
Steam or vapor escaping from around the door.
Light reflection around door or outer case.
Dimming oven light and change in blower sound
may occur while operating at power levels other
than high.
If you need more help...call, toll free: GE Answer Center
POSSIBLE CAUSE
in your home may be blown or the circuit breaker tripped. Replace fuse or
A fuse
reset circuit breaker.
Unplug your microwave oven, then plug it back in.
Make sure 3-prong plug on oven is fully inserted into wdl receptacle.
Door not securely closed.
START pad must be touched tier entering cooking selection.
Another selection entered aheady in oven and CLEWO= pad not touched to
cancel it.
Make sure you have entered cooking time after touching TIME COOK I & II pad.
START pad.
Make sure you have entered a temperature after touching TEMP COOK pad.
Make sure You have entered a code number after touching A~O ROAST pad.
has been forgotten or not seated properly in oven wdl when using Temp
Probe
Cook or Auto Roast function.
The cooktop lamp is located directiy below the oven floor. When the lamp
is on, the heat it produces makes the oven floor get warm. This is normal.
All these things are normal with your microwave oven:
Dull thumping sound while oven is operating.
Some TV-Radio interference might be noticed
while using your microwave oven. It's similar to
the interference caused by other small appliances
and does not indicate a problem with your oven.
@
/ 800.626.2000/ consumer information service
33