DSC Mounting Plate HS-MP Series Installation Instructions

Introduction

The HS-MP series of mounting plates are for use with the DSC Concourse Home
Systems modules and DSC Power and Maxsys security system products. The Concourse
modules and kits include the mounting plates. To install DSC security products in
Concourse cabinets one of these plates is required. A wide variety of Power and Maxsys
products can be accommodated by the three plate sizes.

Contents of Package

The package contains the following parts:
• Four HS-MP200 small plates, or
• Two HS-MP300 medium plates, or
• One HS-MP400 large plate.
Installation Instructions
1. Insert the standoffs (not supplied) into the mounting plate as per Figure A, matching
the hole pattern on the Concourse, Power or Maxsys module to be installed.
2. Align the module over the standoffs and snap into place.
3. Locate a suitable mounting location for the module inside the cabinet.
4. Align the two mounting tabs with the holes in wire raceway and insert as per Figure B.
5. Snap the module into place by pushing the opposite side towards the back of the cabinet.
Mounting
Pin
Module
Raceway
Mounting
Tabs
Plate
Mounting Plate
In sta l l a t ion In s tr u c t ion s
Mounting Plate
Tabs
Standoffs
Figure A
Cabinet
Figure B
HS-MP Series
Raceway
Tabs
Mounting
Plate
Cabinet