Maintenance - Electralog 20" Compact Owner's Manual

Maintenance

  WARNING: Disconnect power
before attempting any main-
tenance or cleaning to reduce
the risk of fire, electric shock or
damage to persons.
!
NOTE: The fireplace should
not be operated with an accumu-
lation of dust or dirt on or in the
unit, as this can cause a build up
of heat and eventual damage. For
this reason the heater must be
inspected regularly, depending
upon conditions and at least at
yearly intervals.
Light Bulb Replacement
Light bulbs need to be replaced
when you notice a dark section of
the flame or when the clarity and
detail of the log exterior disap-
pears. There are two bulbs under
the log set which generate the
flames and embers.
Helpful Hints:
replace all light bulbs at one time
if they are close to the end of their
rated life. Group replacement will
reduce the number of times you
need to open the unit to replace
light bulbs.
Light Bulb Requirements
Quantity of 2 clear chandelier
or candelabra bulbs with a J-12
It is a good idea to
(small) socket base, 60 Watt rat-
ing. Example GE 60BC or Philips
60 CTC. Do not exceed 60
Watts per bulb.
Replacement:
CAUTION:
minutes for light bulbs and heater
to cool off before touching bulbs
to avoid accidental burning of
skin.
1. Unplug the unit from power
outlet.
2. On the back of the Compact
Fireplace remove the screws
from the light access cover
(Figure 4).
3. Remove the light access
cover.
4. Reach into the opening,
locate and examine the bulbs
to determine which bulb(s)
require replacement.
5. Unscrew the bulb(s) counter
clockwise.
6. Insert new bulb(s).
7. Install the light access cover
and install the screws.
Glass Cleaning
The glass is cleaned in the factory
during the assembly operation.
During shipment, installation, han-
Allow at least 5
11