Searching For Your Code - Entone Hydra User Manual

Universal remote control

Hide thumbs Also See for Hydra:

Searching for Your Code

If your home entertainment device does not respond to the remote control after trying all codes listed for you

brand, or if your brand is not listed at all, try searching for your code.

For example, after trying all of the code for your TV, you still cannot get the remote control to operate your

TV, then:

Turn on your TV

On the remote control, press TV once. Then press and hold SETUP until the TV key blinks twice, then

release SETUP

Press the POWER key once

Aim the remote control at the TV

Press either the "CHANNEL UP" key or "CHANNEL DOWN" key to do device auto-scan:

1. Press the "CHANNEL UP" key to start searching upward at an approx. 5 seconds interval for each code

set. The TV key will be on and blink every 5 seconds while in the device scan mode.

Note: In this search mode, the remote control will send IR codes from the library starting from the lowest

code set number to the end of code set for that device; OR

2. Press the "CHANNEL DOWN" key to start searching downward at an approx. 5 seconds interval for each

code set. The TV key will be on and blink every 5 seconds while in the device scan mode.

Note: In this mode, the remote control will send IR codes from the highest code set number to the

beginning of code set of that kind of device

If the TV turns off, a working code has been found. Press OK once to lock in the code. The selected mode

key will blink twice

To search for the codes of other devices, repeat the above but substitute the AUX key for the auxiliary device

you are searching for.

If all code sets of that device is exhausted in the search and the OK is not pressed, the selected device key

will fast blink 7 times and the search mode will be terminated.

Universal Remote Control User's Manual

Page 2