Camera Setup; Fine Tuning; Night Light; Power Supply - Swann baby monitor User Manual

Setup
1

Camera Setup

1
.1

Power Supply

The camera uses either 4 AAA-Size batteries (alkaline battery recommended)
or the household AC power current.
Loading the Batteries
1. Loosen the screw on the bottom of the camera by using a screw driver.
2.Open the battery compartment cover . See Fig. 3.
3.Insert 4 AAA-size batteries (follow the plus (+) and minus (-) signs inside the
battery compartment). See Fig. 3.
4.Close the battery compartment cover, and make sure it is locked securely.
Note 1: Do not mix old batteries with new ones.
Note 2: Remove the batteries from the camera if you do not plan to use it for
a prolonged period of time.
5.Slide the POWER switch to the ON position. The LED on the camera
will light up (red light). See Fig. 3.
Note : When battery power is sufficient, the light is constantly red ;
is low, the LED light will start blinking
Using AC Power
1.Plug one end of the provided power adapter into a wall outlet and the other end
into the bottom of the camera. See Fig. 4.
Note: Use the adapter labeled OUTPUT: 6V DC with the camera.
2.Slide the ON/OFF switch to the ON position. The LED on the camera will
light up (red light). See Fig. 4.
1
.2

Fine Tuning

Place the camera in a convenient location, point the lens towards the observation
area and adjust the angle by rotating the lens head. See Fig. 5.
For best performance we recommend that you keep the monitor at least 1 meter
away from the camera.
1

Night light

.3
Press the night light button, the night light LEDs will remain ON. See Fig. 6.
2
.
See Fig. 3.
when the battery