Programming Device Control; Searching For Codes; Checking Codes - JynxBox remote control User Manual

PROGRAMMING DEVICE
CONTROL
Each of the additional device keys
controls a particular type of device.
For example, the DVD/VCR key
controls your VCR, DVR, or DVD
player, but not your TV, unless you
specify otherwise. See
"Reassigning Device Keys."
Control this
Device Key
Type of device
TV
TV
DVD/VCR
DVD, VCR, DVR,
HTIB, TV/VCR,
TV/VCR/DVD,
and TV/DVD
CABLE Cable box only
AUDIO Amplifier, Tuner
To specify a device
1. Look up the device you want to
control in the device code list on the
back of this guide.
2. Press and hold a device key (AUDIO,
DVD/VCR, or TV) for at least six
seconds. The LEDs for each device
key light up, then the LED for the
device you selected remains on.
3. Enter the four-digit code. The device
key LED turns off briefly after each
key press.
Note: You have 10 seconds to press
each digit. If it takes longer than that,
the remote "times out" and you must
begin again.
4. If the remote recongnizes the code, the
device key's LED blinks three times.
You can now test the remote by pressing
POWER. If your device responds (turns
off), you have found the right code. If
your device does not respond, repeat
steps 2-3 with the next code in the list.
If the remote does not recongnize the
code, the LED will turn off. Retry the
code (by repeating steps 2-3 using the
next code listed for your brand), or
search for a device code.
See "Searching for Codes".

SEARCHING FOR CODES

If none of the codes listed under "Device
Codes" on the back of this guide match
your device, you can search for a set of
commands that will work. Your remote
will sample all the codes in its system
for that device mode to find one that will
allow you to control your device.
1. Press and hold a device mode key
(AUDIO, DVD/VCR, or TV) for at
least six seconds. The LED for each
device key lights up, then the key for
the device you selected remains on.
2. Press a function key (such as Power
or Mute). The following function keys
are valid for searching
(Power is recommended):
- Power
- Mute
- Play
- CH +
- Stop
The device key's LED blinks three
times, then turns off.
3. Press ▲. The remote will send the IR
command for the function you pressed
in Step 2.
4. If the device performed the function
you pressed, press OK. The remote will
now control the device you selected in
Step 1. If the device did not perform the
function you pressed, repeat step 3.
Press ▼ to retry the previous code.
Tip: Note the code set that worked,
in case you must re-code your remote:
DVD/VCR:
TV:
AUDIO:
See "Checking Codes" for more
information on noting code sets.

CHECKING CODES

1. Press and hold a device mode key
(AUDIO, DVD/VCR, or TV) for at
least six seconds. The LEDs for each
device key light up, then the key for
the device you selected remains on.
2. Enter 9 9 0 to tell the remote you are
verifying the device code.
The LED blinks twice.
3. Press 1, then count the LED blinks
and write down the number. If the LED
does not blink, the number is 0. This is
the first digit of the device code. Press
2, 3, and 4 to obtain all four-code digits.
(english) 2 of 4