MEI 710E-3DD Installation Instructions Manual

1. Installation Instructions

Suitable Installation Place

Where the floor is solid and level Where ventilation is good
• Unstable installation causes vibration and • More than 10 cm from 3 sides (left, right
noise of refrigerator. and back) is good enough for ventilation.
• Wooden floor or carpet can be discolored • Insufficient space causes the noise of
under the refrigerator. vibration, weakening of refrigerating
power and the waste of electricity.
• Doors look hanged down due to the twist
of refrigerator unless it is leveled.
The electrical plug must be accessible without moving the set.
Grounding
Grounding terminal is the green one connected to the power cord in the back of refrigerator.
Grounding is necessary water can splash easily ;
where bathroom etc.
Grounding by using
Bury copper plate to whitch grounding wire is connected 25 cm deep in the ground.
grounding wire
Grounding by using Short-circuit breaker is a must where the floor is always wet, for example, fish shop,
short-circuit breaker restaurant kitchen etc.
Grounding is not necessary in case of using side-grounded outlet.
You should not connect the
water pipe, gas pipe, telephone line,
ground wire to
lightening-rod.
There can be explosion or fire.

Correct usage of Refrigerator

Plug in the refrigerator * See page for
2
right after installation.
details.
Set the both * When the surrounding
compartments' temperature is hot in
temperature to "3" to midsummer, do not
perform preparatory run open and shut the doors
for 2 or 3 hours. too often after
When the inside is cold
installation.
enough, put the foods in.
Where there is little or no heat, moisture
• Direct sun lays, side heat of stove and gas
range can weaken the refrigerating power.
• Avoid location by a sink or where moisture
and water can cause rust and corrosion.
• Avoid location where moisture can cause
electrical problems.
• Use hard board or plank on the
concrete/cement floor.
there is much moisture ; any wet and/or watery
basement etc. places.
Side
Grounded
outlet
Grounding wire

Installation Process

Attatch the height adjustable legs to their holes in the
left and right bottom of refrigerator.
Adjust the height by turning the legs until they touch the floor.
• Let the right adjustable leg touch the floor firmly, while the
left, smoothly.
1