Fluff Clean
Special programmes
This programme is executed to clean the drying circuit of any fluff
deposits. The time at which the programme needs to be run is determined
l
automatically by the washer-dryer and indicated by the (Fluff Clean)
l
symbol on the display panel. The
(Fluff Clean) symbol remains lit until
the programme has been successfully completed.
To run the Fluff Clean programme, proceed as follows:
Make sure that the drum is completely empty and close the door.
Set the programme selector to Fluff Clean.
Press the Start/Pause button.
At the end of the programme, the Fluff Clean symbol goes out.
You can also run the Fluff Clean programme at any time without
i
prompting from the appliance.
Rinse + Spin
:
An additional rinse cycle with a final spin. If the laundry is to be removed
dripping wet, set the spin speed to $ (Rinse stop) before starting the
programme → page 13.
Empty + Spin
:
Drain the rinsing water following a programme with $ (Rinse stop)
→ page 13.
Turn the programme selector to Empty + Spin.
Set the spin speed to $ (Rinse stop).
Press the Start/Pause button.
or
Drain and spin at the desired spin speed:
Turn the programme selector to Empty + Spin.
Press the Spin rpm button repeatedly until the desired spin speed is
set.
Press the Start/Pause button.
12