Before You Call For Service - GE Monogram ZDK910 Use And Care Manual

Save time
and money!
Review the
troubleshooting
tips on this
page first and
you may not
need to call
for service.
PROBLEM
WARMING DRAWER
WILL NOT WORK
DRAWER DOES NOT
SLIDE SMOOTHLY
OR DRAGS
EXCESSIVE
CONDENSATION
NO HEAT IN THE
PROOF SETTING
FOOD DRIES OUT
POSSIBLE CAUSE
• A fuse in your home may be blown or the circuit breaker tripped.
Replace the fuse or reset the circuit breaker.
• Warming drawer not plugged in. Plug in.
• Warming drawer controls improperly set. See the Using the Warming
Drawer section.
• Ball bearings are out of alignment. Fully extend the drawer and push
it all the way in. See the Care and Cleaning section.
• Drawer over-loaded or load unbalanced. Reduce weight to less than
50 pounds. Redistribute drawer contents.
• Liquid in warming pan. Remove liquid.
• Uncovered foods. Cover food with lid or aluminum foil.
• Temperature setting too high. Reduce temperature setting.
• Incorrect Moisture Selector setting. Set the Moisture Selector to the
open vent setting to allow venting.
• Room temperature may prevent the thermostat from tripping on.
Turn the knob to LOW then back to PROOF.
• Moisture escaping. Cover food with lid or aluminum foil.

Before You Call For Service...

Electric Warming Drawer
13