Page 1
HearthGate Model G70 For hearths 6’ wide by 2’ deep Made in Denmark for: www.kidco.com KidCo, Inc. Phone 847-970-9100 300 Terrace Drive 847-970-9109 Optional 8” section (G70-8) or 24” section (G70-24) Mundelein, IL 60060 available for larger areas. Patents pending...
• Intended for use with children • Use only spare parts available 6 Nuts for Wall Covers (F) from 6 months through 36 from KidCo. months. • Never allow child to climb or • Check the stability of the gate swing on gate.
Page 3
Unpacking Assembly Unpack your folded HearthGate™ on a Removing or adding sections: stable surface, making sure handle is on top. Note: Always begin separating gate from Each corner is connected by plastic, inter- either end. At the juncture of every section is locking hinges.
Assembly Installation Remove hinge cap (H) from bottom of original Installing the wall mountings: end section. A screwdriver may be needed to Fold wall cover (A) around vertical bar at end pry it off. Place under bottom hinge. Remove of gate. plastic cone from under top hinge of original end section.
Page 5
(see ”Important Notes” page 2). If min. 20” this is not possible with sections included, optional 24” sections are available from your HearthGate™ dealer or KidCo. Slide the assembly as close to cone as pos- Now you are ready to mount other end of 20a.
The locking bar should release from bottom frame (2). KidCo will either repair, or at our option replace, free of charge, any parts necessary to correct Door can now swing open in either direction. defects in material or workmanship during the warranty period. This warranty is complete and exclusive.