GE AG_07 – 7,000 BTU models Owner's Manual And Installation Instructions page 13

5
Install the Case in the Window
Open the window and mark the centerline of
A
the window stool.
Carefully place the case on the window stool
B
and align the center mark on the bottom front
with the centerline of the stool.
Pull the window down behind the top
C
mounting rail.
NOTE: Do not shut the window so tightly that movement of
the accordion panels is restricted.
Loosely assemble the sill supports.
D
INDOOR
Bolt
Select the position that will place the sill
E
supports near the outermost point on the sill.
Attach the sill supports to the case track hole in
relation to the selected position using 2 type A
screws in each support.
Frame guide
F
G
H
OUTDOOR
Sill support
Nut
Adjust the bolt and the nut in each support so
that the case is installed with a slight tilt to the
outside. Use a level; about 1/3 bubble will be
the correct case slant to the outside.
Secure the case to the window stool by using
3 type B screws.
Sill
support
Pull the accordion panels to each window
sash track. Attach them on each side to the
window sash and the window stool using
4 type C screws.
13