Philips 46PFL9707 User Manual page 12

CAM
Insert a CAM module
Switch off the TV before inserting a CAM.
Look on the CAM for the correct method of insertion.
Incorrect insertion can damage the CAM and the TV.
Use the Common Interface slot on the left side of the TV to
insert the CAM card*. Gently insert the CAM as far as it will
go and leave it in the slot permanently. It may take a few
minutes before the CAM is activated. Removing the CAM will
deactivate the broadcast service on TV.
* The Common Interface slot accepts a PC card (PCMCIA) in
which you insert a smart card. Both cards should be supplied
by the TV broadcaster.
If a CAM is inserted and subscription fees have been paid,
(connection methods can differ), you can watch the TV
broadcast. The inserted CAM is exclusively for your TV.
CAM settings
To set passwords or PIN codes for the CAM TV broadcast,
press h and select S Setup and press OK.
Select Channel settings > Common Interface.
Select the CAM TV broadcaster and press OK.
Set-top box STB
Use 2 antenna cables to connect the antenna to the Set-top
box (a digital receiver) and the TV.
Next to the antenna connections, add an HDMI cable to
connect the Set-top box to the TV. Alternatively, you can use
a SCART cable if the Set-top box has no HDMI connection.
12
Switch off timer
Switch off this automatic timer, if you only use the remote
control of the Set-top box. Do this to prevent the TV to
switch off automatically after a 4 hour period without a key
press on the remote control of the TV.
To switch off the Switch off timer, press h and select S
Setup and press OK.
Select TV settings > General settings > Switch off timer and
select Off.
Satellite receiver
Connect the dish antenna cable to the Satellite receiver.
Next to the antenna connection, add an HDMI cable to
connect the device to the TV. Alternatively, you can use a
SCART cable if the device has no HDMI connection.
Switch off timer
Deactivate the Switch off timer, if you only use the remote
control of the Satellite receiver. Do this to prevent the TV to
switch off automatically after a 4 hour period without a key
press on the remote control of the TV.
To deactivate, press h and select S Setup and press OK.
Setting up / Connect devices