Advertisement
MODEL 2711
OPERATION
(Figures 4 and 5)
This Fan may be operated by the Manual Controls located
on top of the unit (as shown in Figure 4) or by the Remote
Control (shown in Figure 5).
1. Place the Fan on a firm and level surface.
CAUTION:
Plastic or rubber tabs, like the feet on this unit,
may stick to furniture surfaces and/or hardwood floors. The
unit may leave a residue that could darken, stain or leave
permanent blemishes on the finish of certain furniture sur-
faces, including wood surfaces, and/or hardwood floors.
2. Plug the cord set into a 120 volt outlet.
Be sure that the plug fits tightly into outlet.
When plugs fit loosely into receptacles, they
may slip partially or completely out of the
receptacle with only the slight movement of
the attached cord. Receptacles in this con-
dition may overheat and pose a serious fire
hazard; if covered by a curtain or drape, the
fire hazard is even greater.
Timer Button
New 11/10
3. Turn the Fan ON by pressing the Power Button ( ).
4. SPEEDS: Press the Fan Speed Button ( ) to desired
speed setting. Each time the Fan Speed Button is
pressed, the speed will change from High (3), to Medium
(2), to Low (1). When the Fan is turned OFF and ON again,
the unit will resume the speed at which it was turned
OFF.
5. OSCILLATION: Press the Oscillation Button ( ) to start
and stop the oscillation function.
6. TIMER: The timer function allows the unit to be set to
operate for a length of time from 1 hour to 7 hours, in
increments of 1 hour. Press the Timer Button ( ) to set
the length of time desired. Each time the timer button is
pressed, the time is increased by 1 hour. After reaching
7 hours, pressing the timer button once more will reset
the Fan to continuous running. The lights on the front of
the unit will light up appropriately with the length of time
that the Fan is set for.
7. To turn the Fan OFF, press the Power Button ( ) and
unplug the unit from the electrical outlet.
Power
Oscillation
Button
Button
Speed Button
Figure 4
4
ENSAMBLADO
1. Cuidadosamente retire el ventilador de la bolsa plástica y de
la caja de cartón. Para fácil ensamblado, apoye el ventilador
de modo tal que la parrilla frontal y el panel de control apunten
hacia arriba.
2. Tome las 3 bases de soporte y ensámblelas entrelazando la
base frontal con la base trasera (Figura 1).
3. Pase el cable de alimentación eléctrica por el canal del cable
situado en el centro de la base (Figura 2).
4. Alinee los orificios de la base de soporte con el inserto roscado
en la parte inferior del ventilador. Asegure los (3) tornillos
mariposa en los cuatro agujeros en la parte inferior de la base
(Figura 3). Utilice la mano o un conductor de tornillo de Philips
para apretar.
5. Dirija el cable de alimentación eléctrica por detrás de la base
de soporte como se muestra (Figura 3).
Paso 1
Base
Frontal
2711ES
New 11/10
MODELO 2711
Orificios de la
base de soporte
Base
Trasera
Ensamblado de la base
de soporte
Figura 1
Cable Eléctrico
9
Orificio del
Cordon
Figura 2
Figura 3
2711ES
Advertisement
