Weslo Cadence 700 Treadmill User Manual page 7

3. Hold a Frame Spacer (27) against the right side of the
Frame (79) as shown. Insert a 4" Bolt (70) into the indi-
cated hole in the Frame Spacer and the Frame. Next,
tighten a 3/4" Tek Screw (3) into the Frame Spacer and
the Frame. Then, remove the Bolt. Repeat this step on
the other side of the Frame.
4. Raise the Right Handrail (59) and the Left Handrail (not
shown) so the Base (46) is flat on the floor. Next, posti-
tion the Handrails near the Frame (79).
Locate the Wire Harness (60). Next, locate the long
piece of tape in the large hole near the lower end of the
Right Handrail (59). Wrap the end of the tape around the
end of the Wire Harness as shown in drawing 4a. Then,
tighten the included plastic tie securely around the tape
and the Wire Harness as shown in drawing 4b.
5. With the help of a second person, lift and hold the Frame
(79) between the Right Handrail (59) and the Left
Handrail (not shown). Finger tighten a 4" Bolt (70) with a
3/8" Washer (66) and a 3/8" Star Washer (29) through
the Right Handrail and the Frame Spacer (27) into the
Frame. Do not tighten the Bolt yet. Repeat this step on
the left side of the treadmill.
3
79
4
79
4a
60
Tape
5
59
79
7
27
3
70
59
46
Tape
60
4b
60
29
66
27
Tie
70