GE GFDN100 Owner's Manual page 13

Reversing the door swing.
STEP-BY-STEP INSTRUCTIONS (cont.)
2 #8 Machine Screws
13
Remove Door Assembly
2. Open the door to approximately 90 degrees. Remove the 4 screws starting
from the bottom to the top. Make sure the door is supported while removing
the screws.
Remove the
four screws
3. Loosen the top screw as shown. Unhook the door by lifting and pulling as
shown by the arrows.
4. Lay the door down on a soft protected flat surface so that the inner part faces
upward (door resting on the handle side).
5. Remove the 6 large tapping screws (#10) located around the perimeter
6 #10
of the door outlining the gasket, and the 2 machine screws (#8) on the hinge
Large
side.
Screws
2 #8
Machine
Screws
6. With the screws removed, turn the door over and separate the silver cover part
of the door from the door frame and set aside.
7. Unlock the 4 tabs on the plastic cover and separate the plastic cover from
the frame.
NOTE: Disregard the "DO NOT REMOVE" label on the plastic cover.