Table of Contents
Advertisement
IS76 Ferrite Antenna
The Antenna is best fitted to be mounted vertically on a door's frame. In any case, the middle
of the antenna should be at a height of 1 meter from the floor. The antenna has to be fixed by
two screws, according to the figure below.
30mm +/- 1mm
Remove the cover caps at both ends of the antenna by sliding them against the outside
Secure the antenna against the wall with both screws
Replace the cover caps by sliding them over the housing
Note:
Even if the functionality of the Ferrite Beacon System is not affected by the presence
of metallic items, it is not recommended to fix the antenna directly against such items.
In order to avoid overheating of the IS76 Beacon Controller, install the antenna at least
1.5 cm away from metallic frames or surfaces.
IS76 Beacon Controller
The IS76 Beacon Controller can be fixed with two to five screws on the wall. Two holes at 60
mm interval are provided for direct mounting on connection boxes.
The three upper holes are used for positioning the device and cannot be reached from the
Connection Compartment.
Two of the lower holes can be reached from outside and thus used for fixing the device.
FCC Statement
Note:
This device complies with Part 15 of the FCC Rules [and with RSS-210 of Industry Canada].
Operation is subject to the following two conditions:
(1)
this device may not cause harmful interference, and
(2)
this device must accept any interference received, including interference that may
cause undesired operation.
Note:
Changes or modifications made to this equipment not expressly approved by (manufacturer
name) may void the FCC authorization to operate this equipment.
__________________________________________________________________________________________________________________
Edition: October 2013 Document N°: F.01U.136.807 V2
540mm +/- 1mm
600mm 0/-10mm
Figure 2
2 X
D 5.5mm
Page 6 of 10
Advertisement
Table of Contents
