Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Audioaccess AAS88
Summary of Contents for Audioaccess AAS88
- Page 1 ® ® AAS SERIES AAS88 OWNER’S GUIDE...
- Page 2 THANK YOU FOR CHOOSING AUDIOACCESS In 1987, Audioaccess pioneered the We are confident that when com- Please take a moment to register development of whole-house audio bined with our controllers, ampli- your product on our Web site, systems that combined superlative fiers and touchscreen keypads, www.audioaccess.com.
-
Page 3: Speaker Placement
SPEAKER PLACEMENT Low-frequency sounds are It is generally recommended that When using two AAS88 in-wall normally omnidirectional, meaning the speaker be installed so that subwoofers, you may need to be the listener can’t tell where they the bottom of the speaker is concerned about phase, as the are generated from. -
Page 4: Speaker Connections
If bass response seems low, both speakers identically: (+) on try inverting the polarity on one Since the AAS88 is a passive loud- the speaker to (+) on the amplifier subwoofer – i.e., connect the (+) speaker, only speaker-level con- and (–) on the speaker to (–) on... -
Page 5: Connection Method
AAS88 loudspeaker or connec- right low frequencies. tion panel. Connect the Output 1 Connection Method #1, Using Two AAS88 Loudspeakers (Use Shorting Straps) Receiver/Amplifier Speaker Outputs Left Right –... - Page 6 Although the subwoofer or LFE output on your receiver/processor may already be crossed over, the AAS88’s network will not interfere with the higher-order processing Connection Method #2, Using One AAS88 in Mono Mode (Use Shorting Straps) Amplifier Receiver/Processor Rear of AAS88** Speaker-Level...
-
Page 7: Installation
INPUT 1 INPUT 2 OUTPUT 1 OUTPUT 2 Right *** Use corresponding inputs on rear of AAS88 speaker when installed without back box. INSTALLATION Tools Needed The Audioaccess AAS Series in- wall speakers were designed to be easily installed. However, if... -
Page 8: Existing Construction
EXISTING CONSTRUCTION AAS88 NOTES: Level • Use the cardboard template when cutting the drywall. Although the AAS88 may be oriented either horizontally Template or vertically, the installation procedure is the same. • Please be aware the template is slightly oversized to allow for... -
Page 9: New Construction
NEW CONSTRUCTION You may either purchase the optional AAS88 back box kit, or you may install the speaker after the wallboard has been installed Detail A by following the instructions for existing construction on page 8. L-Brackets INSTRUCTIONS FOR INSTALLING THE AAS88... - Page 10 Detail A be installed over it. 9. Make the connections from your receiver/amplifier to the AAS88 back box connections panel, and to any other speak- ers as appropriate for your sys- tem, following the instructions on pages 4–7. Connect the...
-
Page 11: Troubleshooting
• Consider adding a separate power tured or touching each other. amplifier to drive the AAS88 sub- • If more than one pair of main woofer. speakers is being used, check the •... -
Page 12: Specifications
© 2005 Harman International Industries, Incorporated. DESIGN GOAL: Combine the superior performance of traditional All rights reserved. Audioaccess loudspeakers with the convenience of in-wall installation. Audioaccess is a trademark of Harman International Polymer-coated aluminum cone with rubber surround Industries, Incorporated, registered in the United States WOOFER TYPE: and/or other countries.
Need help?
Do you have a question about the AAS88 and is the answer not in the manual?
Questions and answers