Remote Control Features; Electronic Display; Battery Replacement - Danby DAC 8009EE Owner's Use And Care Manual

REMOTE CONTROL
FEATURES
Electronic Display: Displays the following
information;
A: Remote Control power On/Off and Mode
Icons
B: Clock and Auto-Timer settings
C: Current set temperature
D: Fan speed setting Control Buttons
1) Power switch.
2) Mode
3) Fan Speed
4) Energy Saver
5) Auto-Timer
6) Used to increase or decrease temperature
settings in 1° increments on the Celsius or
Fahrenheit scale.
7) Cancels current Timer ON/OFF settings.
8) Lock prevents the remote control settings
from inadvertently being changed.
9) Clock: Depress the button for 3 seconds in
order to set the clock. Press the increase or
decrease arrow to adjust the clock in 1 minute
intervals, holding down the increase or
decrease arrow will adjust the time in 10 minute
intervals.
10) Used to activate the SLEEP program.
11) Toggle the LED backlight on/off.
12) Restore remote control default settings.
To operate the hand held remote control will require two "AAA" Alkaline batteries (included ).
Batteries should be replaced when:
a) No signal (beep) is heard when attempting to program the main unit.
b) The main unit does not respond to a command issued by the remote control.

Battery replacement:

1) Slide the rear cover on the remote in the direction of the arrow. Continue pulling (gently) until
the cover separates completely from the unit.
2) Insert (2) batteries (AAA) following the same orientation (polarity) depicted inside the battery
chamber (+/-).
3) Re-install rear cover.
4) If the remote control will not be used for extended periods of time (vacations etc.), batteries
should be removed.
The remote operates within a range of 8 meters (26 ft.) from the receiver located inside
the main unit. Any obstruction between the receiver and remote may cause
signal interference, limiting the ability to program the main unit.
OPERATING INSTRUCTIONS
8