Table of Contents
Advertisement
When to charge the battery New battery packs are shipped in a low charge condition and must be fully charged
before use. It takes approximately 8 hours to fully charge a new battery and 3-5 hours once the battery has
been used in the tool a few times.
Charging of batteries should not be undertaken casually.
Through the charging cycle the condition of the battery pack should be monitored and the charge cycle turned
off at completion or at the end of the recommended time. Unplug the charger from the mains supply and leave
it for at least 15 minutes. After this time you can charge a second battery pack.
Additional safety instructions related to the battery pack and battery safety
• Use only the batteries supplied with the tool.
• Do not use the battery to power any device other than the tool it was sold with.
• Charge the battery only with the charger supplied with the tool.
• Do not charge the battery in a place where static build-up is likely to occur.
Know your product
This drill is mainly used for drilling in wood or metal sheet and screwdriving. Use the tool and accessories only
for intended applications. All other applications are expressly ruled out.
1. Keyless Chuck
2. Handle
3. Variable speed trigger switch with electric brake
4. Forward, Lock, Reverse control
5. Rechargeable lithium ion battery pack
6. LED battery indicators
7. Battery pack release button
8. Torque adjustment collar
9. 2 Speed gear selector
10. Plug pack charger
11. LED Charging indicators
12. Spirit level
13. Drill light
14 Lanyard carry strap
15 Double ended driver bit
16 Chuck collar
Unpacking
Due to modern mass production techniques, it is unlikely that your Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been
rectified.
Failure to do so could result in serious personal injury.
Advertisement
Table of Contents
