Mounting the Network Camera - Wall Mount
1. You can install the camera to a vertical surface by driving screws through the holes shown below.
2. You may also install the bracket to a 4" x 2" utility box (as outlet or switch socket).
3. Another option is using the 15° tilt bracket so that the camera can be installed to an over-looking
position. Attach the bracket to a utility box, and then secure the mount bracket. You can route the
cable through the hole in the middle.
4. Attach a rubber seal pad to the bottom of the mount bracket.
5. Install the camera. Make sure the RJ-45 connector is properly connected.
2
1
4
15° tilt bracket
3
5
EN - 4