INTRODUCTION: NAPCO’s FW-RA-LED Annunciator is an 8 Circuit Annunciator for use with NAPCO’s FW-C2Z, FW-C4Z, FW-C4EZ Fire Alarm Control Panels, that mounts into a standard 4-gang electrical boxes, which may not be expanded. Control access is by a keyswitch. Each Circuit Indicator is a bi-colour LED that is automatically configured to match the Fire Alarm Control Panel configuration.
AC On, Common Trouble, Signal Silence, Buzzer Silence, Lamp Test. 8 Circuit Status LED’s. WIRING INSTRUCTION: The RS-485 Wiring to the FW-RA-LED Module is recommended to be Twisted Shielded Pair as shown in the diagram. The wire gauge may be; 22 AWG up to 2000 ft.
DIP SWITCH SETTINGS: Each Annunciator needs to be assigned a unique, sequential “Address”. This is done with DIP Switches, which also allow disabling of some buttons. SW1-1 Address A0 SW1-2 Address A1 > Address “A3” is always “off”. SW1-3 Address A2 SW1-4 When “off”, the System Reset and Signal Silence slide-switches are always disabled, regardless of the operation of the keyswitch.
WARRANTY NAPCO SECURITY SYSTEMS, INC. (NAPCO) by the security professional, shipping costs prepaid and warrants its products to be free from manufacturing insured to NAPCO. After repair or replacement, defects in materials and workmanship for 12 months NAPCO assumes the cost of returning products under following the date of manufacture.
Page 6
Head Office: FIREWOLF Advanced Fire Products NAPCO Security Systems, Inc. 333 Bayview Avenue AMITYVILLE, N.Y. U.S.A. 11701...