NAPCO NP-RB1224VDC/6 Installation Instructions

R
333 Bayview Avenue
Amityville, New York 11701
For Sales and Repairs, (800) 645-9445
For Technical Service, (800) 645-9440
© NAPCO 2005
FEATURES
• Six (6) relay modules per cluster, each can easily be
separated.
• 10 amp/120VAC/28VDC SPDT contacts.
• 12VDC or 24VDC selectable operation.
• Coil draws 50mA.
• Screw terminals allow up to 12-gauge wire.
• Board dimensions: 40mm W x 22mm H x 50.5mm L
Item
1
2 Double Stick Foam Tape
BREAK-A-WAY RELAY 6 PACK
CUT J1 FOR 24V
2 OFF
ON
1
LEAVE J1 SET 12V
J3
CUT J1 FOR 24V
ON 2 OFF
1
LEAVE J1 SET 12V
J3
Description
Instruction Sheet
NP-RB1224VDC/6

INSTALLATION INSTRUCTIONS

1. In order to break the relay cluster apart (if de-
sired) put a pencil on a flat surface, position the
scoring line on top of the pencil and push lightly.
Relay should easily breakaway from cluster.
2. Connect trigger input or voltage source to screw
terminals marked [POS (+) & NEG (-)]. (Unit is
factory set for 12VDC operation - cut jumper for
24VDC operation).
3. Connect screw terminals marked [N.C. (Normally
Closed) or N.O. (Normally Open) and C
(Common)] to operate desired devices.
CUT J1 FOR 24V
ON 2 OFF
1
LEAVE J1 SET 12V
J3
CUT J1 FOR 24V 2 OFF
ON
1
LEAVE J1 SET 12V
J3
APPENDIX LIST
Dimension
120*80
60*20*7mm
WI1331B 12/05
CUT J1 FOR 24V 2 OFF
ON
1
LEAVE J1 SET 12V
J3
CUT J1 FOR 24V
OFF
ON 2
1
LEAVE J1 SET 12V
J3
Volume Memo
1
6PCS