About The Controls On The Air Conditioner - GE AGM24 Owner's Manual And Installation Instructions

About the controls on the air conditioner.

Features and appearance may vary.
Lights next to
the touch pads
on the air
conditioner
Energy
control panel
saver on
indicate the
selected
settings.
Fan on
Controls
ON/OFF Pad
Turns air conditioner on and off.
TEMP/TIME Increase
Use to set temperature when in COOL mode
or the time when using the TIMER feature.
MODE
Use to set the air conditioner to COOL,
ENERGY SAVER or FAN mode.
FAN SPEED Pad
Use to set the fan speed to LOW (F1),
MED (F2) or HIGH (F3).
Power Outage Recovery Feature
In the case of a power outage or interruption, the
unit will automatically re-start in the settings last
used after the power is restored. If the TIMER
Remote Control
s
To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.
s
The remote control signal has a range of
up to 21 feet.
4
Cool on
Timer on
COOL
ENERGY
SAVER
FAN
TEMP
TIMER TIME
FAN
MODE TIMER
SPEED
Air Conditioner Controls
v
/Decrease
POWER
TIMER Pad
ON—When the air conditioner is off,
it can be set to automatically come on in
w
Pads
1 to 24 hours at its previous setting. Each
touch of the Increase v /Decrease w pads
will set the timer in hours.
OFF—When the air conditioner is on,
it can be set to automatically turn off in
1 to 24 hours. Each touch of the Increase v /
Decrease w pads will set the timer in hours.
To cancel the timer, press the TIMER pad
until the display time disappears.
Remote Control Signal Receiver
Display
Shows the set temperature or time remaining
on timer.
feature was set, it will resume its countdown.
You may need to set a new time if desired.
s
Make sure nothing is between the air conditioner
and the remote control that could block the
signal.
s
Make sure batteries are fresh and installed
correctly as indicated on the remote control.
POWER
TEMP/TIME
FAN SPEED
TIMER MODE
Remote Control