Saving Temps And Speeds - GBC 4064WF-1 Installation And Operating Manual

GBC 4064WF-1 Operation Manual

Saving Temps and Speeds

The operator is able to save Temps and Speeds for certain processes on the 4064WF-1.
When operating the laminator in the lamination mode, the operator can save the Speed, Top
Heat, & Bottom Heat.
For each Gap or Pressure setting, one job can be saved.
Ex: When the GAP is set on 0", the TOP & BOTTOM Heat can be saved, as well as the
speed.
To Save the TOP Heat
:
Press "TOP TEMP"
Rotate the Master Dial until the desired Temp is displayed.
Press and hold "TOP TEMP".
When the "TEMP" on the LCD stops Blinking, the Temp for this Setting is saved.
To Save the BOTTOM Heat
:
Press "BOT TEMP"
Rotate the Master Dial until the desired Temp is displayed.
Press and hold "BOT TEMP".
When the "TEMP" on the LCD stops Blinking, the Temp for this Setting is saved.
To Save the Speed
:
Press "SPEED".
Rotate the Master Dial until the desired Speed is displayed.
Press and hold "SPEED".
When SPEED stops blinking, the Speed is saved.
NOTE:
When operating the laminator in the ACCUSHIELD mode, the operator can only save the
Speed, & Top Heat.
© 2009 GBC an ACCO Brands Co. Page 10