Advertisement
Assembly
Begin by finding the two legs
and the upper cross member.
The legs must be oriented
correctly so that the larger holes
are on the outside of the unit.
The smaller hole must be facing
toward the inside of the unit.
Lay the upper cross member on
the floor, then align one of the
legs with the end of the cross
member so the bolts can be
inserted through the leg and
into the upper cross member.
A
Use the bolts identified as (
)
in the hardware section to
secure the leg to the upper cross
member. The 5mm Hex tool
should be used on these bolts.
Once completed, repeat this
step on the other leg.
5
©2006. General Binding Corporation. All rights reserved
Advertisement
