Antichlorine Filter; Setting The Clock; Length Of Warming Time (Automatic Shut-Off Time); Making Drip Coffee - DeLonghi BCO320T Owner's Manual

Owner manual
Hide thumbs Also See for BCO320T:
Table of Contents

Advertisement

Antichlorine filter

The filter eliminates the taste of chlorine in the water. T o install
the filter, proceed as follows:
Release the filter support from its slot by pulling it up-
wards (fig. 1).
• Remove the Antichlorine filter from the plastic sachet and
rinse it under a running tap (fig. 2).
• open the filter support and carefully put the filter in place
as shown in fig. 2.
• Close the filter container carefully (fig. 2), and reposition
it in its slot, pushing it firmly downwards.
• The Antichlorine filter should be replaced after 80 cycles,
and at least after every 6 months of operation.
Preparation of drip coffee

Setting the clock

When the coffee machine is connected to the outlet for the
first time, the numbers 0:00 will flash on the display.
To set the time, proceed as follows:
1. Press the " hoUR" button (Fig. 3) for about 2 seconds until
the number of hours on the display begins to increase.
2. Before the display stops flashing (about 5 seconds), set
the hour by pressing the hoUR button repeatedly.
3. set the minutes by pressing the MiN button (Fig. 3) re-
peatedly. (To speed up the operation, hold the button
down.)
4. After setting the time, wait 5 seconds. When the display
stops flashing, the time set is stored.
To reset the time, press the hoUR button for about 2 sec-
onds, and then follow the procedure as described starting
from point 2.
Please note: in the event of a temporary power failure, the
time set does not remain stored in the memory.
Programming the automatic start (AUTO BUTTON)
The appliance can be programmed to make drip coffee auto-
matically.
First, make sure that the time is set correctly.
To set the delayed start (i.e. the time you want the coffee to be
made), proceed as follows:
1. Press the AUTo button (Fig. 4) for about 2 seconds until
0:00 flashes on the display.
2. Before the display stops flashing (about 5 seconds), set
the desired hour by pressing the hoUR button repeat-
edly.
3. set the minutes by pressing the MiN button repeatedly.
4. After 5 seconds, the display will stop flashing and the
programmed time will be stored.
5. After you have programmed the machine as described
above, just press the AUTo button to have coffee made at
the time set (the AUTo indicator light will illuminate).
Please note:
if you want to change the start time after it has been set,
press the AUTo button for about 2 seconds and then set a
new time as described starting from point 2.
Keep in mind that at the time set, the appliance will start
to make drip coffee only. The espresso maker does not
come on.

Length of warming time (Automatic shut-off time)

The appliance is factory-set to keep the coffee warm for two
hours after startup.
however, this setting can be changed as follows:
1. Press the oN/oFF button (Z- Fig. 5) for about 2 seconds
until 0:00 flashes on the display.
2. Modify the time by repeatedly pressing the hoUR button
(and also the MiN button if required).
3. After setting the time, wait 5 seconds. When the display
stops flashing, the time will be stored.
Please note: if 0:00 is set, the appliance switches off. (you
can set a time within 1 minute and 11hours and 59 minutes).
Aroma
you can enhance the flavor of your coffee by pressing the ARo-
MA button after the
a unique brewing process, slowly releasing water into the filter
basket; saturating coffee grounds a little at a time extracting
the best flavor and aroma from your coffee.
To activate, press the ARoMA button (fig. 6); the light on the
button will illuminate.
Press the button again to turn the selection off.
it is recommended to use the aroma button when preparing 5
cups or less: do not use this button if brewing an entire carafe
of coffee.
you can select this function even when using the auto func-
tion.

Making drip coffee

open the filter-holder door, rotating it towards the right
(fig. 7).
• Fill the carafe to the level indicator relative to number
of cups of coffee you wish to prepare, taking care not to
exceed the MAX level (fig. 8), otherwise, in order to not
overfill the machine, the excess water will spill out from
the back of the unit.
• Then pour the water into the water-fill compartment of the
appliance (fig. 9).
• Position the gold tone filter (if applicable), or paper filter,
into the filter-holder (fig. 10).
8
Drip coffee
oN/oFF button. This feature activates
en

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bco330tBc0320tBc0330tCoffee maker

Table of Contents