NComputing OfficeStation L110 User Manual page 31

Type "ipconfig" in the DOS command line and press Enter. IP address, Subnet mask, and Gateway that was allocated to the Host PC will be displayed
on the screen.
Input the displayed IP address into Terminal Server network address.
If you finished the setting, click "Save". Click "Connect". (or Try Again)
Your OfficeStation terminal should be connected to the Host PC. You are now ready to use your OfficeStation terminal.
Connecting by Using a Switch (Supports 100 Mbit/sec Switching)
To connect by using a switch, you have to set a static IP address on both the OfficeStation terminal and the Host PC. To configure an IP address
as static, follow these steps :
Click "Start" and click "Control Panel". (In Windows 2000, click "Start", click "Settings", and then click "Control Panel")
Click "Network and Internet Connections", and then click "Network Connections". (In Windows 2000, double click "Network and Dial-up
Connections")