Table of Contents
Advertisement
3
Press the
(Power) button on the front panel
to turn the power on.
CAUTION
Unplug the power cord before moving the
Monitor to another location. Otherwise electric
shock may occur.
WARNING
To avoid injury to the fingers when adjusting
the screen, do not hold the upper part of the
stand as shown below.
Do not touch or press the screen when
adjusting the angle of the monitor.
WARNING
Attach the rubber like the below picture.
If not, the fingers can be pinched or get
damaged.
ASSEMBLING AND PREPARING
NOTE
Front
Rear
Tilt from 15 to 58 degrees up or down to
y
y
adjust the angle of the Monitor set to suit
your view.
Avoid using the product in a high
y
y
temperature and high humidity area. Moving
the monitor from a environment like this to
an air conditioned area may cause moisture
formation inside the glass. This moisture
will be dissipate over time, which may vary
depending on the operating environment.
Using the Kensington security system
The Kensington security system connector is
located at the back of the Monitor set. For more
information of installation and using, refer to the
manual supplied with the Kensington security
system or visit http://www.kensington.com .
Connect the Kensington security system cable
between the Monitor set and a table.
NOTE
The Kensington security system is optional.
You can obtain it from most electronics stores.
7
Advertisement
Table of Contents
