Aluratek APC02B Quick Start Manual

Lithium-ion Battery Case for iPhone 5
Quick Start Guide
aluratek.com

Charging

No need to take the iPhone out of the case. Simply use the included
Micro USB cable and plug into any USB port on your computer or the
orginal iPhone power adapter (not included).
The LED's located on the back of the device will blink when charging.
The capacity is shown by the number of LED's.
When the case is powered on, the iPhone is charging and/or using the
power from the case battery. If the iPhone is drained of power, the case
will first charge your iPhone. If the iPhone is fully charged, the battery will
drain from the case battery first before using the iPhone battery.
To check the battery status, press the button located on the back of the
case. Four LED's means the case is fully charged, and one LED means
it is almost empty.
APC02B
qsg Q10304 Copyright © 2013 Aluratek, Inc. All Rights Reserved.

Installation

1
.
Pull the top of the
battery case off.
3.
Ensure the iPhone
is well connected to
the 8-pin connector.
Tech Support & Warranty Information
If you need further assistance, please contact the Aluratek support department for
troubleshooting prior to returning this device.
E-mail: support@aluratek.com
Web: www.aluratek.com/support
Local (Tustin, CA): 714-586-8730
Toll free: 1-866-580-1978
Aluratek warrants this product against defect in material or workmanship for
1 Year from the date of purchase.
For more information, please visit: http://aluratek.com/warranty-return-policy
You can register your product online at: http://aluratek.com/product-registration
2.
Slide the iPhone 5
into the case.
4.
Slide back the top
of the case and
click into place.