Internal Connectors - Asus H81-M2 User Manual

1.7.2

Internal connectors

1. ATX power connectors (24-pin EATXPWR, 4-pin ATX12V)
These connectors are for ATX power supply plugs. The power supply plugs are
designed to fit these connectors in only one orientation. Find the proper orientation and
push down firmly until the connectors completely fit.
H81M2 ATX power connectors
•
•
•
•
2. TPM connector (20-1 pin TPM)
This connector supports a Trusted Platform Module (TPM) system, which securely
store keys, digital certificates, passwords and data. A TPM system also helps enhance
network security, protect digital identities, and ensures platform integrity.
H81M2 TPM Connector
The TPM module is purchased separately.
1-14
ATX12V
+5V Standby
PIN 1
H81M2
For a fully configured system, we recommend that you use a power supply unit
(PSU) that complies with ATX 12V Specification 2.0 (or later version) and provides a
minimum power of 350W.
DO NOT forget to connect the 4-pin ATX +12V power plug. Otherwise, the system will
not boot up.
We recommend that you use a PSU with higher power output when configuring a
system with more power-consuming devices or when you intend to install additional
devices. The system may become unstable or may not boot up if the power is
inadequate.
If you are uncertain about the minimum power supply requirement for your system,
refer to the Recommended Power Supply Wattage Calculator at http://support.asus.
com/PowerSupplyCalculator/PSCalculator.aspx?SLanguage=en-us for details.
TPM
H81M2
EATXPWR
+3 Volts GND
+12 Volts +5 Volts
+12 Volts +5 Volts
+5 Volts
Power OK -5 Volts
GND GND
+5 Volts GND
GND GND
+5 Volts PSON#
GND GND
+3 Volts -12 Volts
+3 Volts +3 Volts
PIN 1
PIN 1
Chapter 1: Product introduction