PEB7226SF
GE Profile
Series 2.2 Cu. Ft. Countertop Microwave Oven
™
Dimensions and Installation Information (in inches)
Exterior Dimensions (in inches)
W x H x D
24-1/8 x 14 x 19-3/4
Optional Accessory Trim Kits for GE Microwave Ovens
(Available at additional cost)
For a custom built-in appearance, these kits allow built-in
installation of the countertop microwave oven into a wall or
cabinet alone and are U.L. approved for installation over a
GE single electric wall oven. These kits should not be installed
over a gas wall oven.
Accessory trim kits
"Z"
30" Deluxe
29-3/4"
27" Deluxe
26-3/4"
Note: 120V, 60-cycle, grounded power receptacle location
optional on back within cabinet opening.
Installation Information: This information is not intended to
be used for installing unit described. Before installing, consult
installation instructions packed with product/kit for current
dimensional data.
Max Height
Trim Kits
19-1/8"
JX7230SFSS
19-1/8"
JX7227SFSS
For answers to your Monogram,
or Profile
™
Series appliance questions, visit
our website at geappliances.com or call GE
Answer Center
service, 800.626.2000.
®
19-1/8"
Z
*For ADA compliance, the microwave must be
installed no higher than 36-1/4".
Accessory Trim Kits
Z
Cafe
Series
®
™
JX7230
29-3/4"
JX7227
26-3/4"
25-1/2" ± 1/8"
A
C
B
36" MIN.*
Cabinet overlap requirements
A - Overlap of trim kit over top of cabinet
B - Overlap of trim kit over bottom of cabinet 1-3/8" 1-3/8"
C - Overlap of trim kit over sides of cabinet
Note:
Allow an additional inch
of clearance beyond trim
frame on all sides
Specification Revised 12/13
16-3/4" ± 1/8"
22" MIN.
receptacle
in cabinet
19-1/2" MIN.
receptacle
outside
cabinet
30"
27"
1"
1"
2-1/8"
5/8"
Listed by
Underwriters
Laboratories
240379
Need help?
Do you have a question about the PEB7226SFSS and is the answer not in the manual?
Questions and answers
Is this a replacement for the GE profile model JE216OSFO3 and will it fit in the cabinet the JE 215OSFO3 came out of
The GE PEB7226SFSS has exterior dimensions of 24-1/8" W x 14" H x 19-3/4" D. To determine if it will replace the GE Profile JE216OSFO3 and fit in the same cabinet, the dimensions of the JE216OSFO3 must be known. Since the provided context does not include the dimensions of the JE216OSFO3, it is not possible to confirm compatibility.
This answer is automatically generated