Dwz-B70Hl - Sony DWZB70HL Operating Instructions Manual

f Cable clamp
Secures the cable of the supplied AC adapter.
g DC IN 12V (power input) connector
Connect the supplied AC adapter here.

DWZ-B70HL

Body-pack transmitter (transmitter: ZTX-
B02RC)
a Antenna cover
Contains the antenna.
Caution
Do not squeeze the antenna cover. Doing so will weaken
the signal that is transmitted, decreasing the transmission
range.
b BATT/CHARGE (remaining battery / charge)
indicator
Lights when the unit is turned on. This indicates the
remaining battery charge or the charge status.
Indicator Status
Lit (green) Good
Lit (red) Almost dead
Lit (orange) Charging
The remaining battery indication only appears when
alkaline dry cell batteries are being used.
c ENCRYPTION switch
Allows you to use the encrypted transmission function.
For details on the encrypted transmission function, see
"Enabling Encrypted Transmission" (page 18).
d Audio input connector
Connect the supplied microphone or use a guitar cable
(GC-0.7BMP; not supplied) to connect a guitar or similar
instrument here.
e AUDIO/MUTING indicator
Indicates the input level of the audio signal and the status
of the muting function.
Indicator Status
Lit (green) Audio input present
Lit (red) Excessive audio input
Off Audio input weak or nonexistent
Blinking Muting function enabled (i.e., audio
(orange) disabled)
f INPUT switch
Set this based on the connected equipment.
MIC: Set to this position when a microphone is
connected.
INST/LINE: Set to this position when a guitar or audio
equipment is connected.
Caution
Do not set the switch to the MIC position while inputting
audio from an audio mixer or similar device. Outputting
audio at excessive levels may distort audio or damage the
playback/recording device.
For details on the setting, see "System Configuration
Examples" (page 22).
g ATT (attenuator) switch
Set the attenuation level based on the connected
equipment.
Attenuation level (dB) When to use
0 Standard switch position
10 Set to this position if the AUDIO/
MUTING indicator on the receiver
occasionally lights red.
20 Set to this position if the AUDIO/
MUTING indicator on the receiver
is always lit red.
h Battery compartment
Insert two LR6 (size AA) batteries here.
For details on how to insert batteries, see "Inserting
Batteries" (page 12).
i POWER/MUTING button
Turns the unit on or off. This button can also be used to
enable or disable the muting function.
Function Button operation
Turn power on Press the button for at least 1
second
Turn power off Press the button until indicator
turns off
Enable muting function Press the button
Disable muting function
j Channel display
Displays the transmission channel.
11
Parts Identification