Advertisement
Damage to this device from failure to observe these warnings may void the warranty!
Prevent use of spotting scope Yukon 100x in direct sun light.
WARNING! NEVER OBSERVE THE SUN EITHER DIRECTLY OR WITH THE
OPTICAL DEVICE.
USE AND TESTING
• Remove the scope from the carrying case.
• Mount the device on a tripod and adjust the necessary height.
• Remove protective lens caps from the objective lens (1) and the eyepiece (2).
• Place the switch of the objective lens (3) in the primary position of 6 -25x.
• Adjust the variable power mechanism (4) to a desired magnification. The top line of the magnification
display (5) indicates the current power selection for the light path of the 25 mm lens. The bottom line indicates
the power of the 100 mm lens.
• Adjust the position of the eyepiece to a comfortable level by turning the ocular body (6), when your
Spotting Scope has rotating eyepiece.
• Bring image into focus by turning the eyepiece (2).
• To switch the light path to the 100 mm lens and achieve 25x -100x magnification, turn the objective
lens switch (3) to position 25-100. Adjust the magnification as desired referencing the bottom line of the
magnification display.
• Focusing is achieved by turning the eyepiece (2).
• To preserve the scope in adverse weather conditions and to make it more versatile, the Yukon 100x
can be used without removing the carrying case. To utilize this feature, safely mount the scope on a tripod
through the opening in the case positioned against the tripod sockets. Open and fasten with Velcro in the open
position the front lens cover and the rear flaps covering the eyepiece.
• To reduce glare, remove the lens hood (1), turn it round and attach to the bayonet at the front of the
scope.
MAINTENANCE
Maintaining the Yukon 100x is simple:
• clean the lenses with professional lens cleaning supplies intended for use with multicoated optics.
• blow any dust or dirt off of the lenses using dry, compressed air.
• clean the Yukon 100x housing with a soft, clean cloth.
WARRANTY
The Manufacturer warrants its products against defects in materials and workmanship for a period of
three years from the original date of a purchase. Any device returned for warranty service must be judged by the
Manufacturer as having been used according to its original design intents. As such, misuse, neglect, or any
abnormal use is not covered by this warranty. The Manufacturer will repair or replace such products or parts
thereof, which, upon inspection by the Manufacturer, are found to be defective in either materials or
workmanship. As a condition of the Manufacturer's obligation regarding warranty work, the product must be
Advertisement
