Advertisement
Advertisement
Related Manuals for MarkBass MICROMARK
Summary of Contents for MarkBass MICROMARK
- Page 1 15.april.2011 owner’s manual mICromarK - mICromarK 801 - mInImarK...
- Page 2 MORE INFORMATION For warranty and service information, please contact your local Markbass distributor (contact information available at www.markbass.it). For more technical information, please visit us at www.markbass.it and fill out the form on the Support page. We hope you enjoy your power amp and use it to make great music! “The Lightning Flash with arrowhead symbol within an equilateral triangle, is intended to alert the...
-
Page 3: Table Of Contents
BLOCK DIAGRAM 3. INTRODUCTION Congratulations on purchasing one of the world’s best bass amplifiers! Markbass amps are built to the highest standards by a small team of skilled technicians in San Giovanni Teatino, Italy. We have spent many years researching not only the highest-quality technologies for bass amp design and construction, but also the practical needs of the working bassist. -
Page 4: Micromark/Micromark 801
Its “big brother, ”... -
Page 5: Functions Overview (Rear Panel)
When you detect a hum from your line out signal, switching the ground lift will more than likely eliminate it. SPEAKER (9) Using a standard 1/4” speaker cable, this jack can be used to connect to a Markbass “Tweeter Box” for increased high end response, or to an 8 ohm extension cabinet to create a louder 60W rig! -
Page 6: Graph
7. MICROMARK/MICROMARK 801 VPF GRAPh DIMENSIONS 8.86” x 8.86” x 8.62” / 22,5 x 22,5 x 21,9 cm (MICROMARK) 10.55” x 10.55” x 10.31” / 26,8 x 26,8 x 26,2 cm (MICROMARK 801) WEIGhT 9.26 lbs / 4,2 kg (MICROMARK) 11.46 lbs / 5,2 kg (MICROMARK 801) -
Page 7: Minimark Product Overview
8. MINIMARK PRODUCT OVERVIEW The Markbass Minimark is a compact, high-quality bass combo amp with a solid-state preamp and an analog power amp, which delivers 150W of power into two 6” neodymium woofers and a piezo tweeter. Connected to an 8 ohm extension cabinet, it delivers 250W of power. - Page 8 8.2 MINIMARK REAR PANEL SPEAKERS ON/OFF (11) Use this switch to turn off the amp’s speakers and extension cabinet (if applicable) when using headphones. LINE OUT (12) This balanced XLR output may be used for recording or live situations. Use an XLR cable to connect your amp to a soundboard, snake or soundcard.
-
Page 9: Block Diagram
(Version factory preset inside the equipment) AUX INPUT impedance: 600 ohm, max. voltage: 15 Vpp Markbass apparatuses are manufactured to be sold and used in the country of purchase, and are factory preset to that country’s voltage. CONTROLS Due to homologation issues, the voltage may not be changed. - Page 10 11. MINIMARK GRAPhS VLE (min-max) 1000 10000 100000 Frequency - Hz VPF (max) 15.00 dB 10.00 dB 5.00 dB 0.00 dB -5.000 dB -10.00 dB -15.00 dB -20.00 dB 10.00 Hz 100.00 Hz 1.000 kHz 10.00 kHz 100.00 KHz...
- Page 12 Product specifications are subject to change without notice Italy - 66020 San Giovanni Teatino (Ch) - Via Po, 52 - Tel. +39 085 446 3755 - Fax +39 085 440 7764 - www.markbass.it - info@markbass.it...