Subscribe to Our Youtube Channel
Related Manuals for Defy Refrigerator Freezer
Summary of Contents for Defy Refrigerator Freezer
- Page 1 Owner’s Manual SIDE x SIDE CONTENTS REFRIDGERATOR Introduction FREEZER Unpacking Installation Electrical Installation Features Getting Started Operating the Refrigerator Operation of Freezer Freezer Guide Cleaning Maintenance Service www.defy.co.za...
- Page 2 INTRODUCTION Congratulations on the purchase of this quality appliance. We, the manufacturer, trust that you will enjoy many years of trouble free use. Please read these instructions carefully before using the refrigerator. This book will provide you with information on how to operate and care for your appliance in order that you gain the maximum benefit from it.
- Page 3 ELECTRICAL INSTALLATION This appliance must be earthed and the manufacturer and the seller do not accept responsibility for any damage due to incorrect electrical connection. This appliance uses a 220-250V/50 Hz power supply. If the mains power cord is damaged, it must be replaced by a qualified electrician. This appliance may not be used with a battery inverter power supply.
-
Page 4: Getting Started
GETTING STARTED Switching on Push the 15-amp plug into an earthed wall socket and switch on the power. • Ensure that both the refrigerator and freezer thermostats, located at the interior lamp • housing and the freezer control panel respectively, are not in the off position. OPERATING THE REFRIDGERATOR Setting the temperature (refrigerator section) A setting midway on the dial should generally give satisfactory results. -
Page 5: Operation Of The Freezer
Always react to the alarm light by ascertaining the cause and taking corrective action. If the light flashes permanently, this indicates that the freezer is not cooling. Please contact the nearest Defy Service Centre. No frost system The freezer defrosts automatically. -
Page 6: Freezing
FREEZING GUIDE Operate the freezer for 12 hours before loading it. • If you are loading bulk into the freezer, load one quarter at a time and allow to freeze • before loading the next quarter. Divide food into reasonable portions according to your requirements. •... -
Page 7: Maintenance
MAINTENANCE Replacing the lamp bulb. Unplug the power cord at the wall socket. • Unclip the light cover by gently pulling the rear edge forward. • Unscrew and replace the bulb by a new one (not exceeding 15 watts). • Replace the light cover by inserting the clip on its front edge into the slot of the •... - Page 8 If you have followed the instructions and still have a problem, contact the nearest Defy Service Centre. They will be able to advise you on any aspect of the machine or send a qualified technician to repair it.
Need help?
Do you have a question about the Refrigerator Freezer and is the answer not in the manual?
Questions and answers
How to set it because now it's not freezing anymore
To set the Defy Refrigerator Freezer to start freezing again, check the following:
1. Ensure the thermostat is set to an ON position.
2. Verify that the power is switched ON.
3. Check if a house fuse has blown or a circuit has tripped and reset if necessary.
4. Confirm that the 15-amp plug is firmly inserted into the wall socket.
5. Ensure the freezer door is properly closed.
6. If the alarm light flashes permanently, indicating the freezer is not cooling, contact the nearest Defy Service Centre.
This answer is automatically generated
I bought a 348l bottom freezer but it came with no plug, I **** having trouble figuring out how to connect it to electricity, I don't even know how I'm supposed to connect the plug if I have to buy my own, can I please get a step to step explanation on the plug, because I have a fridge that's not connected to electricity because I don't know how
To connect the Defy 348L bottom freezer refrigerator to electricity:
1. Push the 15-amp plug into an earthed wall socket.
2. Switch on the power at the socket.
3. Ensure that both the refrigerator and freezer thermostats are not in the OFF position.
Note: The appliance must be earthed and uses a 220–250V/50 Hz power supply. It should not be used with a battery inverter power supply.
This answer is automatically generated